Printable View
I´ve installed 2.3 lite chip in my v 1.1 xbox.
My chip wasn´t flashed so i downloaded 4979 and burned it.
When I start up my xbox with the cd in it, it finds the bios and down loads it. After that it shout downs. So far so good.
But when I start it up again it just starts over and asking for bios?
I tried yesterday with 4978 with the same results and called support that told me to try 4979. But it doesn´t work.
What can I do?
What does the bank1/bank2 switch do?
Have you set the BIOS Flash protection to OFF before you inserted the disc with the BIOS on it?Citat:
Originally posted by Racing
I´ve installed 2.3 lite chip in my v 1.1 xbox.
My chip wasn´t flashed so i downloaded 4979 and burned it.
When I start up my xbox with the cd in it, it finds the bios and down loads it. After that it shout downs. So far so good.
But when I start it up again it just starts over and asking for bios?
I tried yesterday with 4978 with the same results and called support that told me to try 4979. But it doesn´t work.
What can I do?
What does the bank1/bank2 switch do?
The Flash switch its on unprotected and the "bank" switck is on
bank 1. it downloads the bios from the cd but my problem is that it´s starts over when i start it up again.
what shall i do when it downloaded the bios and turned it self off ?
Do I have to change any of the switches ?
Have you installed your X2 2.3 by your self?If yes,have you solder it correctely?
Heres a updated install guide.
http://www.teamxecuter.com/tutorials/23lite_pin.htm
At the Arcive meny,save as.