Citat:
OPERATION:
1. The console MUST be fully OFF (NOT in STANDBY mode) before connecting the USB PS Jailbreak. Depending on the console version you MUST:
PlayStation 3 *.- FAT. Just turn off the console from the rear switch.
PlayStation 3 *.- SLIM. It is essential to disconnect the power cord from the back of the console.
Connect PS Jailbreak to any USB port on the console, taking care not to have anything else connected by USB.
2. Press the POWER button on the console and then pressed the EJECT button. You will see the two LEDs on the PS Jailbreak illuminate while powering ON the console (10 seconds), then one of several things can happen:
- The Green LED is lit. This means that the PS Jailbreak is working properly.
- The Red LED is lit. This means that the PS has not loaded correctly Jailbreak. Usually this happens when not properly pressed Power sequence and then Eject.
- If the end result is the bright Red LED, we repeat the process from the beginning with the precaution of disconnecting the power cord from the back of the PlayStation 3 Slim or cut the current from the switch at the back of the PlayStation 3 Fat.
Men det enda som händer är att både röda och gröna dioden lyser konstant efter 5-6 sec efter ja har startat den.