Xtreme firmware 3.0 for TS-H943 Xbox 360

Hej!

Någon som testat denna än?

World first Media Stealth One Firmware Only Xbox 360 backup and extraction firmware modification!
R.I.P Dad

Features

Stealth Media implemented into firmware. Backups now appear exactly as original disk regardless of which disk check command used by Xbox 360
Enable0800 mode supports extraction of raw PFI (Physical Format Information) and raw DMI (Disk Manufacturing Information)
Support for loading of extracted PFI and DMI from disk
Non-Stealth Backups automatically enhanced with embeded PFI for Xbox 360 and Xbox 1
Included new Video.iso for Xbox 360 and Xbox 1 backups, now the same as originals

Extraction part of firmware enabled with Enable0800 DVD. ISO included. Burn to DVD+R dual layer disk.
In Enable0800 mode, allows drive to function natively under Windows without any hardware conversion/adaptors
Boots all Xtreme Xbox 360 backups
Boots all Xtreme Xbox 1 backups
Boots all Xbox 360 originals
Boots all Xbox 1 originals on Xbox 360
Use on Xbox Live at own risk

Technical details

Backups now automatically have pre-locked PSN range same as stated in extracted PFI sector if exists, or embedded PFI, therefore cannot read extracted SS/PFI/DMI sectors from disk. Currently all original 360 games have same PFI sector but maybe not in future, hence new feature of extracting PFI in Enable0800 mode and read from backup at PSN $4fb1d (Xbox 360) and $605fd (Xbox1) or if these sectors are blank embedded PFI will be used

Backups now support loading of DMI sector. This sector is different for every original 360 game but is currently not checked for, but maybe in future hence DMI can now be extracted also in Enable0800 mode and read from backup at PSN $4fb1e (Xbox 360) and $605fe (Xbox1)

Firmware checks for Enable0800 security sector @ PSN 04FB1F and if found, enables 0800 mode of firmware.
ISO image Enable0800.iso included. Just burn and insert into drive when you wish to extract security sectors or dump games.
0800 mode of firmware deactivated by inserting game backup (Xbox 360 or Xbox 1) or DVD movie or turning off console.
Reads Xbox 360/Xbox 1 security sector from PSN FD021E (Layer 1)
Reads Xbox 360 security sector from PSN 04FB1F (Layer 0)
Reads Xbox 1 security sector from PSN 605FF (Layer 0)
Security sector must be extracted using Enable0800 DVD for Xbox360 games and Xbox 1 games

Innebär detta att det borde funka med att spela backup på original xbox på vanliga dvd skivor, rippad på 'vanliga' sätt? Dvs behöver man inte rippa de speciellt och bränna dual layer med ss fil och allt sånt?

Citat:

---

Original inlägg av TePeL

Innebär detta att det borde funka med att spela backup på original xbox på vanliga dvd skivor, rippad på 'vanliga' sätt? Dvs behöver man inte rippa de speciellt och bränna dual layer med ss fil och allt sånt?

---

Nej! Det krävs fortfarande dl layer discs för att få det att fungera. :D :D

Ok.

Det går alltså inte att använda en vanlig xbox release till 360? De ska vara rippad på en 360 så det blir större image fil osv?

Eller kan man ta en vanlig release med en ss fil och bränna på dual layer och det funkar?

Hej på er :)

Det var ett tag sedan jag befann mig på detta forum.

Jag har en samsung drive och patchade med det första firmwaret som kom ut - det har fungerat utmärkt och jag har inte haft någon anledning att göra förändringar :)

Nu har jag läst lite om Stealth - fattade dock inte vad det innebar förrens jag läst detta:

Citat:

---

* Stealth Media
This is to clear up a few misconceptions about what Stealth Media is and how it works. This is not firmware stealth. Reading the firmware itself for changes is not controlled by the firmware itself, it is a low level hardware function which cannot be stopped by firrmware code.
A firmware check routine which calculated a checksum and returned that to the host was already found in V1 and was modified to always return the correct unmodified firmware value. I think this was a last minute check incorporated by MS as they knew the firmware code was not signed.
Stealth Media is all about making a backup disc appear to the Xbox360 host exactly the same as an original. Although this was already done by the Security Sector and the challenge/response, there remained a number of differences on the disc that are currently not checked for. It would be very easy for the dash or the particular game to perform these extra disc checks. There are four main aspects to Stealth Media:

* PSN Lockdown:
This is a two part process:
-Before disc authentication (security sector,challenge response) is performed the drive will only allow vaild PSN reads as defined in the PFI sector. This is currently the standard video partition. Any request to read outside this range is not allowed - as per originals. (No more reading of the backup PFI,DMI,SS sectors.)
-After disc authentication is performed and the drive is unlocked only valid PSN reads are allowed from the range defined by the Security Sector, this is the standard game partition. Any request to read outside this range is not allowed - as per originals.

* PFI Sector (Physical Format Information):
This sector is contained within the lead-in and contains information about its physical format. Disc booktype, start PSN and end PSN and Layerbreak are contained here. Currently all Xbox360 and Xbox1 games have the same PFI information, but that may change.
On Writable media (our backups), this also contains media specific information such as Media Code/Manufacturer ID and Media Product Revision number.
Any requestes for this information is now redirected to the the PFI sector now at $04FB1D (for Xbox 360 backups) or $0605FD (Xbox 1 backups), if it exists. If it does not exist (pre V3 backup) a seperate embedded PFI is used for Xbox 360 and Xbox 1.

* DMI Sector (Disk Manufacturing Information):
This sector is also contained within the lead-in and contains information about the Disc manufacturer, such as Company name, batch id etc. This is currently different for each Xbox360 and Xbox1 game in each region.
Any requestes for this information is now redirected to the the DMI sector now at $04FB1E (for Xbox 360 backups) or $0605FE (Xbox 1 backups).
A pre V3 backup will always return blank information for this. (A possible detection method.)

* Video Partition:
When Extreme V1 was released ,the disc build included a blanc video partition as it wasnt required for games to boot. As this can be checked by the XBox360 host, the standard video partition from any game was included with the stealth firmware. This is nothing new, just put back in for correctness!

* Conclusion:
As of today , none of these extra disc checks are being performed, but it is only a matter of time before a game will. The same sort of checks were introduced to XBox1 games a while ago. I performed an exhaustive check of every command that the Samsung firmware can respond to and these differences were discovered.
The Samsung firmware only supports a limited subset of commands from the MMC-3/4 standards so not all commands exist compared to a standard PC drive, so anyone testing for media specific information should bear this in mind.
Non-Stealth backups will still boot with stealth firmware and will be enhanced with the PSN Lockdown and PFI Sector embedded in the firmware. These backups will have no DMI and possibly have a blank video partition, both of which can be checked for.
Stealth backups will still boot with non-stealth firmware but will be exposed to the above top three differences (PSN Lockdown,PFI,DMI) making the backup detectable. Correct Video partition is present.

---

Det låter ju bra :)

Nu till frågan - finns det något "enkelt" sätt att lägga in denna stealth-firmware ?

När jag flashade förra gången använde jag några enkla program, typ keydrive Xtractor mfl - fungerar de även med detta firmware ? eller måste jag ändra med typ hexedit ?

Finns det tom någon steg-för-steg guide på någon sida för detta stealth-firmware ?

:)