Using "12v fan mod" method:
Cut the fan's black wire off close to the 3-pin connector. Strip a centimeter (or 1/4 inch) or less off of the black wire. Tape the exposed wire to the case. If you want, you could solder the wire to the case instead, in which case there isn't any need to tape it except for physical reinforcement (so you don't rip the connection if you pull the fan out).


Öhh, räcker det alltså att klippa bort svarta kabeln, så får jag 12 volt?
D.v.s 80mm fläkt går på 12v, XBOX ger 7 volt, genom att kapa svarta och tejpa den på chassit får jag fläkten att snurra i rätt hastighet????? Fattar ingenting.........

Har en Zalman 80mm fläkt och en power cooler 60mm, båda är tysta, men vet liksom inte vilken jag ska sätta i.