PS3 Felkoder - PS3 Error codes

[Pendragon]

PS3 Felkoder - PS3 Error codes


8003041F - An error occurred during the copy operation. (using media server)

8002291B - Registration of the information could not be completed. The game will quit. *Delete gamesaves if it is the first time and game data and or try another Manager software for starting backups*

80710A06 - An error occurred during the install operation (error when downloading
game from PSN - network error occured.

80029301 - An error occurred during the delete operation. (attempting to delete
some ps2 homebrew from virtual mem card)

710102 - DNS Error; No DNS server available.

8013030 - System Error due to failed update download.

80010001 - Major Error , Game ability stopped.

80010006 - An error occurred during the start operation. (corrupted
folding install)

80010007 - An error occurred during the start operation. (during
disc swap tests)

80010014 - Has to do with downloading from the PSN, When you have bought a game and this error occurs, please go to your "recently downloaded/purchases" to download it first try.

80010017 - Can't start Blu-ray Game.

80010036 - An error occured during the delete operation error.

80010510 - Will not play hard drive games - Cause unknown.

80010514 - Disc error detected. Retrying operation.

80010516 - An error occured during the start operation; PS One game swapped using the eject function and then play pressed quickly, PS One game inserted again.

8002F281 - Firmware update problem, most likely bad sectors on HDD, try swapping your 2,5" HDD in your PS3 for a new one and reset and reformat. ( Pendragon )

80029516 - Sign in to PLAYSTATION-Network. (needed for some games or Ps3
processes - have to sign in to use them)

80029023 - Exchanging Key Information exchange has timed out.

80029024 - Cannot Obtain an IP address.

80029513 - Copyright Violation when attempting to install game.

80029564 - Downloaded Game will not install - Cause unknown.

80029946 - Attempting to play burnt Dual layer NTSC disc on a Pal ps3.
(workarouns is to transfer files to ps3 via TVersity)

80029945 - Can?t playback burn BD-R movie. (error message in the picture above)

80030920 - An error occurred during the copy operation. The file may be corrupt or there isnt enough memory. Try copying data from original source.

80031150 - System Settings Fail to Save - Possible Blue Screen "Setting information is corrupted.Press the x button to repair and restore default".

80031601 - Error Creating Account.

80130203 - PS3 connects to internet but not to network - Typically means that the required ports are not open to connect to store but PS3 can connect to internet. Try opening ports , TCP port: 80, 443, 5223 and UDP port: 3478, 3479, 3658. or add Ps3 to DMZ.

80410418 - DNS Error.

80710016 - Playstation Network is down.

80710092 - "An error has occured, you've been signed out from the ps network" - (connection dropped?)

80710101 - Connection error.

80710102 - PS3 Cannot connect to the router with current IP information - Try rebooting your router.

80710541 - The connection to the server timed out.

80710723 - Possible Port Error - Try opening ports , TCP port: 80, 443, 5223 and UDP port: 3478, 3479, 3658. or add Ps3 to DMZ.

81019002 - Error copying saves from location A to location B not open to connect to store but PS3 can connect to internet.

8001050B - Will not play demo hard drive games, when blu-ray disc is inserted - Cause unknown.

8001050D - An error occured during the start operation; PS3 game swapped using the eject function and then play pressed quickly - PS3 game inserted again.

80028EA5 - Unknown - User cannot connect to PS3 network. "Sony told the user to send the machine in".

80028EA6 - Connection error , Possible Proxy error power cord. Then shut off your modem/router, for about 5 mintues, then turn the modem back up first and let it sync, then turn the router back on(if using one) and let it sycn. Reconnect your power cable and flip the back swtich up again. Then make a new network connnection.

80028F10 - Go to Display Settings then HDMI (or whatever your connection is) and choose Automactic, not Custom. I always had it on Custom before. Seems when you choose Automatic it allows the PS3 to select 50hz which is what you need for PAL games that don't support 60hz.

80028F17 - PS2 disc Boot Error , An error occured during the start operation; PS2 game swapped using the eject function and then play pressed quickly - Backup ps2 game inserted again. (ps3rips)

80028F18 - PS2 Disc Error, unsupported disc;
eg. Utility discs, BB discs, IQ Remix game etc. ode).

80028F19 - PS2 Disc Error , fsck; the internal PS2 disk got corrupted and I guess that you can use HDD utility disc to fix it.

80028F1A - PS2 Disc Error , invalbnnetcfg; network config error.

80029C68 - Corrupt data usually on external device.

8002A10D - Unable to Add friend in XMB.

8002A4A6 - Cannot load game to play online.

8002A515 - Error Signing in.

8002A548 - Unable to remain logged in - either to game or server.

8002A705 - Unable to connect to server/host. Check router port configuration.

8002A71A - Possible NAT Error , Can log onto Game Server but can't join game and can't host game.

8002AD23 - Found to be related to a connection issue Check to make sure firewall is off to see if that helps. (possibly network/update error)

8002AE21 - Demo / File cannot be overwritten. Delete original file to install.

8002B241 - DVI has no audio.

8002F147 Cannot update the firmware, Possible solutions, turn off proxys, try not using a firewall, and/or turn off UPnP support.

8002F994 - To many people downloading the update just sit back until the morning around 5am - 11am and you should be able to get it.

8002F997 - Trying to Update the Firmware, copying to a file and installing from a USB drive falied".

8003051E - Game will not Save.

8013013D- "A connection error has occurred" - May be to do with the SSID of the Router or signal strength if the conneciton drops Putting the PS3 into DMZ may help - otherwise check WPA key PS3 can't handle WPA2 only WPA or none.

8013013E - WEP Key error, change WEP key to all numbers (on router homepage) and try agian, or which to WPA.

8013030F - Check Router Page, SSID Broadcasting possibly off.

80410A0B - Internal PSP error, hardware fault. Send back to be replaced/fixed.

807101FF - An error occurred during communication with the server. This is a DNS error.

8071053D - Hard boot the PS3, turn off the PS3 to stand-by, flip off the back swtich and remove the power cord. Then shut off your modem/router, for about 5 mintues, then turn the modem back up first and let it sync, then turn the router back on(if using one) and let it sycn. Reconnect your power cable and flip the back swtich up again. Then make a new network connnection.

80710B23 - PS3 Network is Down or PS3 Network is too busy to respond.

80710D23 - Turn the PS3 off for a bit (30 minutes give or take) with the power toggle. (not standby mode)

80029513 - Copyright Violation when attempting to install game

[Pendragon]

Fler små hemliga trick som inte står specade i manualen:

With the PS3 power switch in the off position, turn power switch back on while holding down Eject button. This "fan test" mode allows you to clean out the Dustmites inside the PS3. It works for Models CECHG and higher. (Note that a plugged in PS3 Slim does not have a power switch at all and is always in standby).

The following requires the power switch in the back to be on...

Hold Power button down for 6 seconds (while PS3 is on): turns off PS3.

Hold Eject button down for 6 seconds (while PS3 is on): force disc to eject.

Hold Eject button down for 12 seconds (while PS3 is on): reset Blu-ray.

Hold Power button down for two beeps (while PS3 is off): Reset video to lowest settings.

Hold Power button down for three beeps (while PS3 is off): Enter PS3 diagnostic mode (repeat procedure twice)

Hold PS button down on controller for 10 seconds: Turns off Sixaxis or Dualshock 3.

The PS3 can enter a special "Service Mode". When it does the bottom right hand corner of the screen has a red translucent rectangle with the words "Playstation 3. Factory/Service Mode" inside of the rectangle. It is rumored that by plugging a special JIG in the USB port, the PS3 is triggered into Service Mode the next time it boots up. This special mode then accepts firmware code loaded in from the USB port, and allows reflashing the firmware chip.

Each PS3 has a special 512KB EEPROM chip on the motherboard using a SPI Serial Interface Renasas chip.

Type: EEPROM
Size: 512KB
Speed: 3MHz
Voltage:
Packaging: 8-pin
Manufacturer: Renesas
Serial Number: HN58X2504TIE
Description: PS3 EEPROM chip

Now that you have gotten here, you should have enough knowledge about the PS3 hardware to move on to the next level. Here are the list of things you can do depending on how interested and motivated you are:

• Beginner
  
  1. Upgrade your PS3 to 2TB using an external 3.5" SATA drive (or internally if you can find a 2.5" SATA drive 9.5mm in thickness)
  2. Disassemble your PS3 and take digital pictures of the front and back of the motherboard for all to see.
  3. Replace the factory thermal grease with Arctic Silver or higher grade thermal compound when you reassemble your PS3.
  
  
• Intermediate
  
  1. Count the number of fan blades and substitute for better fans.
  2. Change the power supply to a compatible one that uses the least amps.
  3. Replace the Blu-ray lens with better quality ones.
  
  
• Advanced
  
  1. Get OtherOs functionality back (possible now with a small hardware purchase) so you can install linux or other custom firmware.
  2. Create some linux programs after you have installed linux, or try to make programs that run from the XMB.
  
  

[Pendragon]

Tråden får gärna klistras

[Pendragon]

Uppdaterar med en ny felkod ( 8002F281 )
Fel vid installation av Firmware, korripta sektorer på HDD, en kotte jag hjälpte med detta fel fick plocka ut sin HDD utr sin Ps3 o scandiska i en PC efter formatering som kryssade de trasiga sektorerna. Dock avrådde jag honom från att använda samma disk i sin Ps3a då det ligger trasiga sektorer på disken.
Men efter ett diskbyte bet mjukvaran han uppdaterade maskinen med bättre

[henkens]

Jag har fått:
80028F14
Vad kan det vara då?

[Swizzy]

googlat på det? vad fick du error coden i samband med?

[henkens]

Har googlat, finns ett antal andra som frågar, men inga svar.
När jag öppnar: app_home/PS3_GAME mappen.

[Swizzy]

Det är normalt... det betyder förmodligen att det inte finns någon sådan mountpoint eller liknande... har inte reflekterat så mycket över felkoden per say, men jag vet att det är normalt typ...

[stefan_fox]

Fick nydligen hem en PS3:a som liter utav att fläckten går upp i varv hela tiden. Till början låter den normalt sedan börjar den låta lite och till slut låter det som att PS3:an skall explodera vad kan det vara för fel??

[Swizzy]

Fick nydligen hem en PS3:a som liter utav att fläckten går upp i varv hela tiden. Till början låter den normalt sedan börjar den låta lite och till slut låter det som att PS3:an skall explodera vad kan det vara för fel??

Dålig kontakt mellan kylfläns och processorerna? trasig temp sensor i processorerna?

[carlus]

jag får 80010017 = - Can't start Blu-ray Game.

vad ska jag göra då för att fixa detta?

*en skiva ska väl vara i ps3 innan jag håller på med multiman o load:ar spel?
eller ska jag ta ut skivan när jag får detta error o prova utan ??